Page 1 of 1

How to enable IPV6

Posted: 03 May 2021 09:46
by Woger
Hi,
After updating EFA, it seems to have diabled the ipv6.

When I try to enable it from console I get a "eth0 is nog an active interface" error. But it's the only interface, and an ifconfig show a ipv4 and ipv6 address.
Can I enable it by manually? Changing ifcg-eth0 to IPV6INIT="yes" didn't help.

Thanks,
Roger

Re: How to enable IPV6

Posted: 03 May 2021 11:00
by Woger
Found out that the ip addresses were configured on eth1 and that interface was disabled. Enabling the eth1 solved the problem.